Two spare 30mm titanium mesh protector discs with countersunk M2 screw holes for thermal devices

Spare 30mm Titanium Mesh Protector for Thermal Device (Set of 2)

Regular price€16.00
/
Tax included. Shipping calculated at checkout.
Add-ons

Add the protector mount and top rail.

Titanium Protector and Mount for OwlSet / Guide 1.2x10 Thermal Monocular +€49.00
Top Mount Rail for OwlSet / Guide 1.2x10 Thermal Monocular +€19.00
  • In stock
  • 2x titanium mesh 30mm

Worldwide shipping starts at 7.90€ and is calculated during checkout based on location.

Orders are usually fulfilled in 1-2 business days and are shipped from our warehouse in Netherlands.

⚠ Duties may apply if you're based outside EU economic zone

This is a replacement part for following thermal protectors:

  • Thermal Protector for Owlset / Guide 1.2x10 Thermal Monocular

Can also be used to make custom protectors for other thermal devices. Uses 4x M2 counter sink screws for mounting. Inner diameter is 20mm (effective diameter) with outside being 30mm in diameter.

Protector check

How close is too close?

The titanium mesh can take a 1.5 J hit point-blank several times before breaking. Playing at even 3.0 J, it is most likely still safe to use for most engagement distances. Enter BB weight and power output to check what's a safe distance.

  • Not safe at all
  • Might survive a single impact
  • Rated for multiple impacts

0.20 g0.49 g
1.0 J≈  fps4.0 J
How was this calculated?

Red: above 2 J. Yellow: 1.5 to 2 J. Green: 1.5 J or less. This is an estimate for a level shot with the hop-up set flat, at 25 °C and sea level, from 1.5 m above the ground. The model counts air drag and hop-up spin. The distance shown is rounded up. Measure your power with a chronograph, with the hop-up on. The picture is not to scale: short distances are drawn wider.

Replace the mesh when it shows visible damage. Under extreme conditions (higher power, heavier BBs, repeated hits on the same spot), 100% resistance cannot be guaranteed.