Allen / Hex Key Holder for HPA Regulator
Allen / Hex Key Holder for HPA Regulator
Allen / Hex Key Holder for HPA Regulator
Allen / Hex Key Holder for HPA Regulator

Allen / Hex Key Holder for HPA Regulator

€7.00 EUR
/
Tax included.
  • Low stock - 4 items left
  • Backordered, shipping soon

Pairs well with:
  • 1x holder
  • 1x 3/32 inch allen key
  • 4x zip-ties

⚠ Zip-ties are required for proper mounting and for hex key retention to work properly. Adhesive tape is only to prevent the holder from moving around.

  1. Choose a place where zip-ties can be wrapped around the regulator all the way.
  2. Degrease the area using rubbing alcohol
  3. Remove the adhesive backing and install the holder in place.
  4. Install both zip-ties and tighten them as best as you can. Trim the excess ends.

Worldwide shipping starts at 8€ and is calculated during checkout.

Orders are usually fulfilled in 1-2 working days and are sent from Latvia (Europe).

⚠ Duties may apply if you're based outside EU customs union!

→ ALWAYS READY TO ADJUST
→ FITS 3/32" & 2.5MM HEX

Don't you hate when you forgot where you put your damn hex key for your HPA regulator? Not anymore.

With this slim hex key holder, you'll always have it ready to go right on the regulator. Fits on most popular regulators like Wolverine, Mancraft, Novritsch and Balystik SMR200 and any of similar size.

Tensioning mechanism allows it to easily carry either 3/32" imperial allen key (comes included in the kit) or 2.5mm hex key.

Made from PA12 Nylon.

Customer Reviews

Based on 1 review
100%
(1)
0%
(0)
0%
(0)
0%
(0)
0%
(0)
R
Rick G. (Utrecht, The Netherlands)
Simple but very effective

Just like the cap, a simple yet effective solution. It was a bit of puzzling on where to put it on my regulator but found a great spot.

You may also like